My PC has good specs (i5-4460, 16gb, rx480 & 500gb ssd) and connection is wired with 1gbps (both machines). I already refunded it so I'm scared if I buy it and the software buggs again when I try to use it, I won't be able to refund it again. The day after I wanted to do some troubleshooting but the non-steam software of virtualhere wasn't able to find my steamlink, do I need to buy it from the steamstore to be able to use it on my steamlink? Really weird stuff.Īfter some looking around I saw the software was free on the official website so I tested if it worked for me and it did too, so I refunded the steam software. The inputs were very laggy, the controller would always press button A every 2 seconds and if I was holding a button for 5 seconds my inputs would be spread randomly over a span of 10-20 seconds. I thought virtualhere would fix my problems so I bought the software from the store and it worked! I hoped my steamlink would be the same, of course not. It's the best.) make sure you have Standard controllers in the ports you want to use the adapter and that Direct Connect is checked in Settings.So I bought a GC adapter for my pc (WUP-028) and installed the drivers on my pc, when I ran dolphin it was plug n play after that and I didn't need to do any configuring. Open the context menu for it by right-clicking and select Properties.Ĭheck box delete the software software for the adapter.Īfter all this is done run dolphin ( use 5886. Open Device Manager or run devmgmt.msc, look for WUP-028 in the Universal Serial Bus devices. If there is a problem in the installation process then you could try uninstalling the adapter's driver back to vanilla state with Windows Device Manager and start over. Make sure to hit Yes to modify the system driver. On the right column select WinUSB and click replace driver. If this method didn’t allow you to resolve the Wii U USB GCN adapter not detected error, move. Repeat this procedure until you run out of compatible drivers. If it isn’t, redo the steps above and select a different driver when you get to step 6. Even if it's not, you might want to try this anyway. Reboot your computer and see if the Wii U USB GCN adapter gets recognized at the next startup. You should have downloaded this one: įom the options menu in Zadig, select List all devices. Both ports, even the gray one that is only for rumble.ĭL and Open Zadig.

Click to expand.If you tried using it in Wii mode, try using it in PC mode.

Wup 028 driver for pc